Log into the router's admin page and go the firmware upgrade section (usually found under administration). Then (again, still holding the button) turn the power on and wait another 30.Ģ. Then, still holding the button, turn the power off and wait 30 more. This means, while the router is power on, press and hold the reset button for 30 seconds. Perform a 30/30/30 hard reset on the router. The router page from the DD-WRT Wiki has the exact instructions on how to flash your router. Next, connect your PC using an Ethernet cable to a LAN port on the VPN router. Grab an Ethernet cable and connect the WAN (internet) port on the VPN router to any LAN port on the primary router. Depending on your router, you may also need to download additional tools, like a TFTP app. This is what we'll be using to flash the router. bin file that you need to download to your PC. The Wiki page should also have a link to a recommended DD-WRT build. We'll need to keep this page open and follow its steps carefully. This will take you to an instruction page for setting up the router. On the router page, you'll see a link to the DD-WRT Wiki page for that router. Double click on the router model to see its page.ģ. This is very important – each router model has unique setup instructions and a recommended DD-WRT build to download. ![]() ![]() Search the Router Database for the model of router you're intending to turn into the VPN router. The examples in this tutorial are going to assume it's 192.168.1.1, but depending on your router model it could be 192.168.0.1, 10.1.1.1 or really any .x or 10.1.x.x variation.Ģ. Make a note of your primary router's LAN IP address (that's the one you use in a browser to access the router admin console). Before you startīefore we get started on the setup, there are a couple of things you should do:ġ. Perform a search for a router model name here, and a list will come up revealing whether the router is supported or not. To check if a given router is supported by DD-WRT, head to the website and click on the Router Database. The router needs to be supported by DD-WRT, which is the name of the firmware we'll be using. We'll be installing special firmware on this router that lets you set it up as a VPN client. ![]() To make this happen, you'll need a second broadband router, one with an Ethernet WAN port (not an ADSL or cable modem router). You can, of course, bounce devices between them as needed, just by connecting to different WiFi networks. Any device connected to the VPN router (again, either wirelessly or with wires) will be routed through the VPN. When this is done any device that you connect to the primary router – either physically through a wired connection or through WiFi – will have regular internet service.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |